| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Reject oversized XDomain properties responses
tb_xdp_properties_request() allocates room for 45 data dwords in its
252-byte response buffer. The XDomain length field is six bits wide,
however, and a malicious peer can set it to 63. After the fixed response
fields are subtracted, the driver treats this as 48 data dwords.
Commit 322e93448d90 ("thunderbolt: Clamp XDomain response data copy to
allocation size") only bounds the copy against data_len. If data_len is
at least 48, memcpy() reads 192 bytes from the 180-byte res->data array,
causing a 12-byte heap out-of-bounds read. Commit 4db2bd2ed478
("thunderbolt: Limit XDomain response copy to actual frame size") limits
the earlier copy but does not constrain this header-derived length.
Reject response data lengths that exceed the allocated source buffer
before copying them into the assembled property block. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: discard post-EOF pagecache when extending a file via zero range
smb3_zero_range() removed the pagecache only for the range being zeroed,
so when it extends the file the folio straddling the old EOF - which may
hold data dirtied past EOF through an mmap - was never dropped and became
visible as file content once the file was extended.
Lower the discard boundary to the smaller of the zero-range offset and the
old EOF. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: split cifsFileInfo bitfields to avoid shared-byte RMW races
The invalidHandle, swapfile, oplock_break_cancelled, offload,
and status_file_deleted fields are stored in the same bitfield byte
in struct cifsFileInfo, but are updated in different code paths that
may run simultaneously, and are protected by different locks. Since
bitfield assignments generate byte-level read-modify-write operations,
a modification to one flag can overwrite a concurrent modification to
another flag.
To avoid these races, convert these flags from a bitfield to
separate bool fields. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: accel: kxcjk-1013: reject duplicate event disable
The IIO core does not filter duplicate writes to the event enable
attribute. kxcjk1013_write_event_config() already ignores repeated
enable requests, but a repeated disable request still calls
kxcjk1013_set_power_state(data, false), dropping a runtime PM reference
that was not acquired for this request. This can underflow the runtime
PM usage count and trigger a "Runtime PM usage count underflow" warning.
Return early when the requested state already matches ev_enable_state. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: adc: ad_sigma_delta: fix use-after-free on unbind
ad_sd_buffer_postenable() allocates sigma_delta->samples_buf with
devm_krealloc() at runtime, so its devres entry sits after all
probe-time entries of the driver. devm resources are released in
reverse allocation order, which means unbind frees samples_buf before
iio_device_unregister() disables the buffers and detaches the trigger
pollfunc. The data ready IRQ is still enabled at that point, so
ad_sd_trigger_handler() can still run and memcpy() incoming samples
into the freed samples_buf.
Fix this by preallocating the buffer in
devm_ad_sd_setup_buffer_and_trigger(), before the triggered buffer and
the IRQ are set up, so it is freed only after iio_device_unregister()
has drained the trigger handler via free_irq(). Size it for the worst
case of all sequencer slots being active; ad_sd_validate_scan_mask()
already caps the number of active channels at num_slots.
This issue was found by an in-house static analysis tool. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: adc: stm32-adc: fix possible division by zero in processed channel
In case the conversion has failed or returned zero, processing *val
can lead to a division by zero. Need to check for errors, or converted
value is zero, before processing the data. In case the converted value
is zero, e.g. the Vrefint channel, this should be considered as invalid
in all cases. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: adc: sun4i-gpadc-iio: clean up on thermal zone registration failure
If devm_thermal_of_zone_register() fails, probe returns without
unregistering the IIO map array or disabling runtime PM.
Jump to err_map to release them. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: adc: xilinx-xadc: free IRQ before cancelling the unmask worker on unbind
The ZYNQ XADC alarm IRQ handler queues zynq_unmask_work via
schedule_delayed_work(); that work is cleared by a devm callback.
Register the devm callback before devm_request_irq() so the devres LIFO
teardown frees the IRQ first, ensuring the handler can no longer queue
work by the time the workqueue is cleared. Otherwise the handler could
re-arm the work and run it after the xadc structure has been freed.
This issue was found by an in-house static analysis tool. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: buffer: serialize buffer teardown with mode claims
Buffer-mode claims hold mlock to guarantee that the device remains in
buffer mode until the claim is released. Normal buffer updates take
info_exist_lock followed by mlock in iio_update_buffers().
However, iio_device_unregister() disables and deactivates all buffers
without taking mlock. This can invalidate buffer state, including
active_scan_mask, while a buffer-mode claim is held.
Take mlock in iio_disable_all_buffers() so that unregister honors the
mode-claim lifetime guarantee. The info_exist_lock -> mlock ordering
matches iio_update_buffers(). |
| In the Linux kernel, the following vulnerability has been resolved:
iio: buffer: Ensure bounce buffer used for unaligned case is zeroed.
iio_push_to_buffers_with_ts_unaligned() leaks uninitialized heap memory
to userspace if the data passed in is not a multiple of 8 bytes and the
timestamp is enabled. Specify __GFP_ZERO for the devm_krealloc()
to ensure any extra space is cleared. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: gyro: adis16136: fix unprotected debugfs reads
The serial_number file operations are open coded and never call
debugfs_file_get(), which debugfs_create_file_unsafe() requires.
debugfs_remove_recursive() therefore does not wait for a read in
progress, and unbind frees the iio_dev underneath it.
Use debugfs_create_file() instead. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: health: max30102: fix NULL dereference in interrupt handler
The interrupt is requested in max30102_probe() and stays enabled
for the lifetime of the device, but indio_dev->active_scan_mask is only
valid while a buffer is enabled. When an interrupt arrives while no
buffer is enabled, the handler dereferences the NULL active_scan_mask:
Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
Call trace:
__bitmap_weight+0x64/0x98 (P)
max30102_interrupt_handler+0x48/0x160 [max30102]
Call max30102_fifo_count() at the top of the handler and return early
unless it reports a FIFO sample is ready. Because FIFO_RDY is the only
interrupt source enabled in max30102_chip_init(), an invocation of
max30102_interrupt_handler() without the FIFO_RDY interrupt status bit
set carries no data to read and can return before touching
active_scan_mask. A negative return from max30102_fifo_count()
indicates a failed interrupt status read and is treated the same way. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: imu: adis16400: fix unprotected debugfs reads
adis16400_serial_number_fops is open coded and never calls
debugfs_file_get(), so debugfs_remove_recursive() does not wait for a
read in progress and unbind frees the iio_dev underneath it.
Commit ae1d37a9bb4b ("iio: imu: adis16400: use DEFINE_DEBUGFS_ATTRIBUTE
instead of DEFINE_SIMPLE_ATTRIBUTE") converted product_id and
flash_count to DEFINE_DEBUGFS_ATTRIBUTE, which protects itself, but
moved all three files to debugfs_create_file_unsafe().
serial_number prints three registers as "%.4x-%.4x-%.4x" and
DEFINE_DEBUGFS_ATTRIBUTE() formats a single u64, so it cannot be
converted without changing what the file returns. adis16475 and
adis16550 already use debugfs_create_file() for their open coded
files. Use it here too. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: imu: adis16480: fix unprotected debugfs reads
The firmware_revision and firmware_date file operations are open coded
and never call debugfs_file_get(), which debugfs_create_file_unsafe()
requires. debugfs_remove_recursive() therefore does not wait for a read
in progress, and unbind frees the iio_dev underneath it.
Use debugfs_create_file() instead. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: light: gp2ap020a00f: drain irq_work after free_irq
The threaded IRQ handler queues data->work through irq_work_queue() so
the trigger is polled from a per-CPU context. free_irq() does not flush
an irq_work the handler already queued, so after gp2ap020a00f_remove()
returns that work may still run and call iio_trigger_poll() on data->trig,
which the devm cleanup has already freed, causing a use-after-free.
Add irq_work_sync(&data->work) after free_irq() in remove() and in the
probe error path, mirroring commit 78601726d4a5 ("iio: trigger: sysfs:
fix use-after-free on remove").
Found by an in-house static analysis tool, confirmed by manual review. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: pressure: bmp280: fix out-of-bounds access in sampling frequency lookup
The sampling frequency tables store each frequency as an integer part and
a fractional part in micro units. num_sampling_freq_avail is initialized
to the number of flattened integer elements because read_avail() returns
the table as a flat array.
bmp280_write_sampling_frequency(), however, indexes the same table as a
two-dimensional array and uses num_sampling_freq_avail as the number of
rows. Convert the flattened element count back to the number of rows
before iterating over the table. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: proximity: pulsedlight: fix iio_device left registered on PM setup failure
pm_runtime_set_active() failing in probe() jumps to error_unreg_buffer,
which only calls iio_triggered_buffer_cleanup() -- it does not undo the
iio_device_register() that already succeeded a few lines above. probe()
then returns the error, the devm-managed indio_dev is freed, but the
iio core still has it registered: the sysfs/chardev nodes stay live and
point at freed memory.
Add an error_unreg_dev label that unregisters the iio device before
falling through to the existing buffer cleanup, mirroring the teardown
order already used in lidar_remove(). |
| In the Linux kernel, the following vulnerability has been resolved:
iio: trigger: cancel reenable_work before freeing trigger
iio_trigger_notify_done_atomic() defers ->reenable() into
trig->reenable_work on the system workqueue, and the worker dereferences
the owning trigger through container_of(). Nothing cancels this work
before iio_trig_release() frees the trigger, so a worker armed by the
last in-flight IRQ can outlive the free and touch freed memory.
Cancel it at the top of iio_trig_release(), which every free path
reaches through the device core's final put_device().
Found by an in-house static analysis tool. |
| In the Linux kernel, the following vulnerability has been resolved:
perf: Require kernel access for text poke events
Perf events with exclude_kernel=1 can be opened without kernel perf
access. However, exclude_kernel does not suppress text-poke sideband
records. Every PERF_RECORD_TEXT_POKE is marked PERF_RECORD_MISC_KERNEL
and contains a raw kernel instruction address.
An unprivileged task can therefore open and mmap a task-local software
event with text_poke=1. Both opening a count-only tracepoint event and
configuring UDP GRO for ESP-in-UDP cause updates to inline static calls;
the observer receives the relocated addresses of the modified instructions.
For a known kernel image, any such address reveals the runtime kernel
text base despite KASLR.
Call perf_allow_kernel() whenever attr.text_poke is set, regardless of
exclude_kernel. Events that neither monitor kernel execution nor request
text-poke records retain their existing permissions. |
| In the Linux kernel, the following vulnerability has been resolved:
tcp: prevent collapsing skbs across boundary in rtx queue
tcp_write_collapse_fence() sets TCP_SKB_CB(skb)->eor = 1 on
tcp_write_queue_tail(sk) to prevent skbs queued after a switch to
device encryption from being collapsed into earlier skbs.
The fence is a no-op if all earlier data has already been transmitted
when the switch happens: sk->sk_write_queue is empty. The not yet
acknowledged earlier skbs wait in sk->tcp_rtx_queue with eor 0.
On a subsequent retransmit or SACK shift, tcp_retrans_try_collapse() or
tcp_shift_skb_data() can then merge an skb queued after the switch into
one queued before it.
Both users of the fence are affected:
- psp: devices only encrypt skbs with skb->decrypted set. The merged skb
keeps decrypted = 0 from the earlier skb, so merged data sent after
psp_sock_assoc_set_tx() is retransmitted in cleartext.
- tls device offload: the merged skb straddles the start marker set in
tls_set_device_offload(). The software fallback (fill_sg_in() returns
-EINVAL) and the mlx5, nfp and funeth drivers cannot handle such an
skb and drop it. Every retransmit rebuilds the same skb, so the
connection stalls.
Fix this in two places, for defense in depth:
1. Fall back to tcp_rtx_queue_tail(sk) in tcp_write_collapse_fence()
when tcp_write_queue_tail(sk) is NULL.
2. Check !skb_cmp_decrypted(to, from) in tcp_skb_can_collapse(), as
tcp_skb_can_collapse_rx() does on receive. skb_shift(), which both
collapse paths call, already has a DEBUG_NET_WARN_ON_ONCE() for this
condition. |
