| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
net: phylink: correctly validate returned PCS in phylink_inband_caps
In phylink_inband_caps(), the PCS returned by mac_select_pcs is only
checked if NULL but mac_select_pcs can also return an error pointer.
This can cause a kernel panic as phylink_pcs_inband_caps() only checks
if passed PCS is not NULL and directly dereference ops from the phylink_pcs
struct.
Use the IS_ERR_OR_NULL macro to address both case where the returned
PCS can be NULL or an error pointer and prevent a kernel panic. |
| In the Linux kernel, the following vulnerability has been resolved:
mfd: sm501: Fix potential memory leaks during remove
The memory allocated for struct sm501_devdata in sm501_pci_probe() and
sm501_plat_probe() is not freed by the corresponding remove functions
sm501_pci_remove() and sm501_plat_remove(). Fix that by adding a call to
kfree(). |
| In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: validate on-media seg_num against the cache device size
seg_num is read from the crc32c-only superblock, so whoever supplies the
cache device on a table load (CAP_SYS_ADMIN) controls it. It sizes
cache->segments[] and is the value every later on-media segment id is
bounded against, yet it is never checked against the device. Because
cache_dev->mapping is the direct map of the pmem, CACHE_DEV_SEGMENT() for
a segment id past the device resolves to ordinary kernel memory beyond
the mapping; a new-cache init reaching such an id has cache_seg_init() ->
cache_dev_zero_range() memset() 12 KiB over that memory -- an
out-of-bounds write into the kernel heap at table load. A zero seg_num
makes the segment allocations ZERO_SIZE_PTR.
Reject a seg_num that is zero, larger than the device can hold, or larger
than PCACHE_CACHE_SEGS_MAX before it is used. |
| In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: detect a cycle in the last-kset chain during replay
cache_replay() follows the on-media last-kset chain by next_cache_seg_id
with no cond_resched(). A forged chain that points back into a segment it
has already visited makes the replay loop follow it forever.
Cap the last-kset hops at cache->n_segs; a valid chain visits each segment
at most once. |
| In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: only hand out initialized cache segments
get_cache_segment() scans the segment map up to cache->n_segs, the
physical device segment count, but cache_segs_init() only initializes
the first cache_info->n_segs segments. A crafted image with
cache_info->n_segs smaller than the device count leaves the remaining
pcache_cache_segment structs zeroed (segment.data == NULL), and the
allocator can hand one to cache_kset_close(), which writes through the
returned segment's data pointer with no NULL check.
Bound the allocator's search to cache_info->n_segs so only initialized
segments are ever returned. A conforming cache sets n_segs equal to the
device segment count, so this rejects nothing legitimate. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: dvm: fix memory leak in iwl_op_mode_dvm_start()
In iwl_op_mode_dvm_start(), jumping to out_free_eeprom currently bypasses
the out_free_eeprom_blob label. Consequently, error paths triggered after
successfully parsing the EEPROM free priv->nvm_data but leak
priv->eeprom_blob.
Fix this memory leak by reordering the error handling labels so
that out_free_eeprom falls through to out_free_eeprom_blob.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under development and is not yet publicly
available. Manual inspection confirms that the bug is still
present in v7.1-rc6.
An x86_64 allyesconfig build showed no new warnings. As we do not have
supported Intel DVM wireless hardware and firmware to test with, no
runtime testing was able to be performed. |
| In the Linux kernel, the following vulnerability has been resolved:
fuse: copy request headers via a stack buffer for io-uring
The fuse-io-uring transport copies req->in.h out to the ring in
fuse_uring_copy_to_ring() and req->out.h back in fuse_uring_commit().
Both headers live inside the fuse_request slab object, whose cache
(fuse_req_cachep) is created without a usercopy whitelist, so copying
them directly to/from userspace trips CONFIG_HARDENED_USERCOPY and
panics:
usercopy: Kernel memory exposure attempt detected from SLUB object
'fuse_request' (offset 56, size 40)!
kernel BUG at mm/usercopy.c:102!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:usercopy_abort (mm/usercopy.c:90)
Call Trace:
__check_heap_object (mm/slub.c:8268)
__check_object_size (mm/usercopy.c:197 mm/usercopy.c:258 mm/usercopy.c:223)
copy_header_to_ring (fs/fuse/dev_uring.c:618)
fuse_uring_prepare_send (fs/fuse/dev_uring.c:776 fs/fuse/dev_uring.c:785)
fuse_uring_send_in_task (fs/fuse/dev_uring.c:1306)
tctx_task_work_run (io_uring/tw.c:96)
task_work_run (kernel/task_work.c:233)
io_run_task_work (io_uring/tw.h:84)
io_cqring_wait (io_uring/wait.c:278)
__do_sys_io_uring_enter (io_uring/io_uring.c:2685)
entry_SYSCALL_64_after_hwframe (arch/x86/entry/entry_64.S:121)
Bounce both headers through an on-stack copy so the usercopy touches
stack memory, not the slab object. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtlwifi: rtl8192du: Fix possible memory leak in rtl92du_init_sw_vars()
The memory allocated inside rtl92du_init_shared_data() is not freed in
any of the subsequent error paths in rtl92du_init_sw_vars().
Fix that by adding a call to rtl92du_deinit_shared_data() in the error
path. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: pci: fix resource leak on failed NAPI setup
rtw_pci_probe() allocates PCI resources through
rtw_pci_setup_resource() before it sets up NAPI. If
rtw_pci_napi_init() fails, the error path jumps straight to
err_pci_declaim and skips rtw_pci_destroy(), leaving the PCI
resources allocated by rtw_pci_setup_resource() behind.
Add a dedicated cleanup label for the NAPI setup failure path so probe
destroys the PCI resources.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing current
mainline kernels. The tool is still under development and is not yet
publicly available. Manual inspection confirms that the bug is still
present in v7.1-rc7.
An x86_64 allyesconfig build showed no new warnings. As we do not have a
suitable rtw88 PCI board to test with, no runtime testing was able to be
performed. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7996: fix TX DMA mapping leak for AddBA req frames
mt7996/mt7992 hand the firmware a HW MAC-TXP for AddBA req action frames
(MT_TXD7_MAC_TXD, set in mt7996_mac_write_txwi_80211()), but are otherwise
FW-TXP devices. On tx free mt76_connac_txp_skb_unmap() therefore decodes
the per-frame txp as a struct mt76_connac_fw_txp. For a MAC-TXP the
fw_txp.nbuf byte aliases the AddBA TID word (MT_TXP1_TID_ADDBA), which is
always zero, so the unmap loop runs zero times and the skb DMA mapping in
buf[1] is never unmapped. buf[1].skip_unmap is set unconditionally, so the
generic DMA-ring cleanup skips it as well.
Each AddBA req therefore leaks one TX DMA mapping, roughly one per
(re)association. With WED enabled these mappings are bounced through the
WED swiotlb pool, so under continuous client reconnect churn the pool is
exhausted after ~1-2 days, after which DMA mapping fails for WED, the WiFi
MCU and other on-SoC consumers.
Keep the deferred (token release) unmap that the design relies on, and add
an mt7996-specific txp unmap that inspects MT_TXD7_MAC_TXD and unmaps
buf[1] from the MAC-TXP layout for those frames, delegating to
mt76_connac_txp_skb_unmap() otherwise. |
| In the Linux kernel, the following vulnerability has been resolved:
timekeeping: Check the return value of tk_get_aux_ts64 in __do_adjtimex()
If the auxiliary clock is disabled during tk_get_aux_ts64() but is enabled
before tks->clock_valid is checked, then uninitialized stackdata will be
used in the calculations and indirectly leaked to userspace.
The same race window also exists after this change and also for the core
timekeeper. But in these cases the only effect would be incorrect
adjustments and this is userspace's responsibility to avoid this. |
| Concrete CMS below 9.5.3 is vulnerable to PHP Object Injection via unserialize()
calls in the Workflow, Form block, and File/Set components that lack the
allowed_classes restriction. The Form block and File/Set sinks were addressed in
9.5.2; the Workflow component sinks were addressed in 9.5.3. An unauthenticated
attacker may trigger arbitrary PHP object instantiation if a malicious serialized
payload has been placed in the database. Thanks XananasX7 and Sanjorn Keeratirungsan
(dizconnect) for independently reporting the original components, and sh4d0byss for
reporting the Workflow component wasn't fixed in 9.5.2. The Concrete CMS security team gave this
vulnerability a CVSS v.4.0 score of 8.4 with vector CVSS:4.0/AV:L/AC:L/AT:N/PR:H/UI:N/
VC:H/VI:H/VA:H/SC:N/SI:N/SA:N. |
| strongSwan 5.0.2 through 6.0.7 allows PKCS#7 certificate enumeration in the openssl plugin that leads to a lack of release of memory after its effective lifetime. |
| There is an HTML injection vulnerability in Esri Portal for ArcGIS versions 11.3 and prior that allows a remote attacker with administrative privileges to insert arbitrary HTML into an administrative API. Users working with ArcGIS Enterprise 11.1, and 11.3 are encouraged to patch. All users are advised to upgrade to the latest long-term support release. |
| There is an HTML injection vulnerability in Esri Portal for ArcGIS versions 11.5 and prior that allows a remote, highly priviliged attacker to insert arbitrary HTML into the Portal for ArcGIS Home application. Users working with ArcGIS Enterprise 11.1, 11.3, and 11.5 are encouraged to patch. All users are advised to upgrade to the latest long-term support release. |
| Improper restriction of XML external entity references in the RemoteQueryCachePlugin in AWS Advanced JDBC Wrapper 3.3.0 through 4.2.0 might allow an actor with write access to the shared cache infrastructure to disclose sensitive files from application hosts that read cached query results, including stored database and IAM role credentials, via crafted XML data in a cached column value.
To remediate this issue, users should upgrade to version 4.3.0 or later. |
| Vulnerability in the Siebel CRM Integration product of Oracle Siebel CRM (component: REST). Supported versions that are affected are 17.0-26.6. Easily exploitable vulnerability allows unauthenticated attacker with network access via HTTP to compromise Siebel CRM Integration. Successful attacks of this vulnerability can result in unauthorized access to critical data or complete access to all Siebel CRM Integration accessible data. CVSS 3.1 Base Score 7.5 (Confidentiality impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:L/PR:N/UI:N/S:U/C:H/I:N/A:N). |
| In multiple locations, there is a possible memory safety issue due to a heap buffer overflow. This could lead to remote code execution with no additional execution privileges needed. User interaction is not needed for exploitation. |
| In multiple locations, there is a possible out of bounds write due to an integer overflow. This could lead to local escalation of privilege with no additional execution privileges needed. User interaction is not needed for exploitation. |
| In parseParts of PduParser.java, there is a possible out of bounds read due to a heap buffer overflow. This could lead to local escalation of privilege with no additional execution privileges needed. User interaction is not needed for exploitation. |
