| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| FreeRDP versions before 3.31.0 contain an information disclosure vulnerability in the RDPGFX server's ResetGraphics PDU serializer that fails to initialize padding bytes in the fixed 340-byte wire format. Attackers can receive uninitialized heap memory including live pointers and GLib function addresses transmitted in the PDU, defeating heap ASLR and disclosing the GLib module base address. |
| Use of uninitialized resource in Windows Win32 Kernel Subsystem allows an authorized attacker to disclose information locally. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: fix info-leak on partial LZNT decompress in ni_read_frame()
ni_read_frame() decompresses an LZNT $DATA frame into the vmapped target
pages and then trusts decompress_lznt()'s return value:
unc_size = decompress_lznt(frame_ondisk, ondisk_size, frame_mem,
frame_size);
if ((ssize_t)unc_size < 0) err = unc_size;
else if (!unc_size || unc_size > frame_size) err = -EINVAL;
decompress_lznt() stops as soon as the compressed stream is exhausted
(e.g. a zero chunk header) and returns the number of bytes it actually
wrote, which may be far less than frame_size. The bytes between unc_size
and frame_size are never written. The only memset() that follows zeroes
the region beyond i_valid; when the frame lies entirely within the file's
valid size that memset() does not run, so the gap retains whatever was in
the just-vmapped pages. All pages are then marked uptodate and returned
to userspace, disclosing uninitialized (recently-freed) kernel page
memory. A crafted compressed file whose stream decompresses to only a few
bytes leaks the remainder of every frame on a plain read(2), which is
enough to recover kernel pointers and defeat KASLR.
Zero the [unc_size, frame_size) tail immediately after a successful LZNT
decompress so the remainder reads back as zero. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: omapfb: panel-dsi-cm: initialize lock before registering display
dsicm_probe() registers the display before initializing ddata->lock.
Once omapdss_register_display() publishes the display, another consumer
can reach a dsicm callback that takes this mutex while it is still
uninitialized.
Initialize the mutex before registering the display so the published
callbacks always see a valid lock. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/dasd: Propagate partial completion length across ERP recovery
dasd_default_erp_postaction() copies the timing and device state from
the finished ERP request back to the original request but drops
proc_bytes. A request that was partially completed, an ESE read of a
not-yet-allocated track returns fewer bytes than requested, and then
recovered through the ERP chain loses its partial-completion length.
__dasd_cleanup_cqr() then sees proc_bytes == 0 and completes the whole
request instead of requeueing the remainder, silently returning zeroed
data for the part that was never read.
Carry proc_bytes over to the original request like the other
per-request state. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: FCP: do not copy out an uninitialised init response
fcp_ioctl_init() allocates its response buffer with kmalloc() and copies
the whole buffer back to userspace:
buf_size = init.step0_resp_size + init.step2_resp_size;
void *resp __free(kfree) =
kmalloc(buf_size, GFP_KERNEL);
...
if (copy_to_user(arg->resp, resp, buf_size))
return -EFAULT;
Nothing clears the buffer, and the only writer of its leading
step0_resp_size bytes is the step-0 control transfer:
err = snd_usb_ctl_msg(dev, usb_rcvctrlpipe(dev, 0),
FCP_USB_REQ_STEP0,
USB_RECIP_INTERFACE | USB_TYPE_CLASS | USB_DIR_IN,
0, private->bInterfaceNumber,
step0_resp, private->step0_resp_size);
if (err < 0)
return err;
usb_fill_control_urb() does not set URB_SHORT_NOT_OK, so a short or
zero-length data stage completes with status 0 and snd_usb_ctl_msg()
returns a small actual_length. The only check is err < 0, so a short
transfer is accepted as success.
snd_usb_ctl_msg() copies the full size back unconditionally:
buf = kmemdup(data, size, GFP_KERNEL);
...
memcpy(data, buf, size);
Bytes the device never wrote are therefore restored into resp unchanged
and copied to userspace. step0_resp_size and step2_resp_size are each
validated only to 1..255, so the caller also picks the slab cache, from
kmalloc-8 up to kmalloc-512.
On 7.2.0-rc5 (arm64), device answering step 0 with a zero-length data
stage, s0 = s2 = 255:
# init_on_alloc off, no spray
step0 window [0,255): nonzero=94/255
000: 00 80 60 06 00 00 ff ff 18 00 00 00 57 01 ea 01
010: 08 78 22 13 00 00 ff ff a8 c4 5f 80 00 80 ff ff
# same kernel, kmalloc-512 pre-seeded with an 8-byte tag
step0 window [0,255): nonzero=219/255 tagbytes=232
# identical run, init_on_alloc=1
step0 window [0,255): nonzero=0/255 tagbytes=0
# all three runs
step2 window [255,510): device words matched=62/62
a8 c4 5f 80 00 80 ff ff is the little-endian kernel text address
ffff8000805fc4a8. The step-2 window is unaffected, so the disclosure is
exactly the step-0 region.
Zero the buffer, and require the step-0 transfer to deliver the full
step0_resp_size bytes so a short data stage is reported as an error.
Discovered by XBOW, triaged by Baul Lee <baul.lee@xbow.com> |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: move ext4_percpu_param_init() before ext4_mb_init()
When running `kvm-xfstests -c ext4/1k -C 1 generic/383` with the
`DOUBLE_CHECK` macro defined, the following panic is triggered:
==================================================================
EXT4-fs error (device vdc): ext4_validate_block_bitmap:423:
comm mount: bg 0: bad block bitmap checksum
BUG: unable to handle page fault for address: ff110000fa2cc000
PGD 3e01067 P4D 3e02067 PUD 0
Oops: Oops: 0000 [#1] SMP NOPTI
CPU: 0 UID: 0 PID: 2386 Comm: mount Tainted: G W
6.18.0-gba65a4e7120a-dirty #1152 PREEMPT(none)
RIP: 0010:percpu_counter_add_batch+0x13/0xa0
Call Trace:
<TASK>
ext4_mark_group_bitmap_corrupted+0xcb/0xe0
ext4_validate_block_bitmap+0x2a1/0x2f0
ext4_read_block_bitmap+0x33/0x50
mb_group_bb_bitmap_alloc+0x33/0x80
ext4_mb_add_groupinfo+0x190/0x250
ext4_mb_init_backend+0x87/0x290
ext4_mb_init+0x456/0x640
__ext4_fill_super+0x1072/0x1680
ext4_fill_super+0xd3/0x280
get_tree_bdev_flags+0x132/0x1d0
vfs_get_tree+0x29/0xd0
vfs_cmd_create+0x59/0xe0
__do_sys_fsconfig+0x4f6/0x6b0
do_syscall_64+0x50/0x1f0
entry_SYSCALL_64_after_hwframe+0x76/0x7e
==================================================================
This issue can be reproduced using the following commands:
mkfs.ext4 -F -q -b 1024 /dev/sda 5G
tune2fs -O quota,project /dev/sda
mount /dev/sda /tmp/test
With DOUBLE_CHECK defined, mb_group_bb_bitmap_alloc() reads
and validates the block bitmap. When the validation fails,
ext4_mark_group_bitmap_corrupted() attempts to update
sbi->s_freeclusters_counter. However, this percpu_counter has not been
initialized yet at this point, which leads to the panic described above.
Fix this by moving the execution of ext4_percpu_param_init() to occur
before ext4_mb_init(), ensuring the per-CPU counters are initialized
before they are used. |
| Use of uninitialized resource in Remote Desktop Client allows an authorized attacker to execute code over a network. |
| An information leakage vulnerability exists in the Endpoint DLP component (epdlpdrv.sys) of Netskope Client for Windows prior to version R141. An internal communication channel used by the user-space hook DLL to pass messages through the kernel driver to the daemon lacked proper token-based message validation, allowing local unprivileged processes to send unauthorized queries. Additionally, a reply buffer used by the port message handler was not properly initialized before returning data, leaking residual kernel pool memory from prior allocations. A local unprivileged attacker could exploit this vulnerability to enumerate DLP configuration and feature flags, extract live session tokens, and read kernel memory fragments from other users' operations. |
| In the Linux kernel, the following vulnerability has been resolved:
nfsd: ensure nfsd_file_do_acquire() does not use a non-opened file
->atomic_open is permitted to return success without actually opening
the file. It indicates this by calling finish_no_open().
This means dentry_create() can return a file which hasn't been opened.
This is extremely unlikely as ->atomic_open handlers typically
use finish_no_open() only for already existing files, and dentry_create()
isn't called in that case, and the parent being locked should prevent
races.
However out of an abundance of caution it seems wise to teach nfsd to
only use the file returned by dentry_create() if FMODE_OPENED is set,
indicating that it has in fact been opened. |
| In the Linux kernel, the following vulnerability has been resolved:
platform/x86/amd/pmc: Propagate SMU errors and validate S2D address
amd_stb_s2d_init() discards the return value of several S2D SMU commands.
When the SMU refuses a command (e.g. "SMU cmd failed. err: 0xff") the
failure is only noticed indirectly - if at all - and reported as -EIO,
masking the real error.
More seriously, the S2D_PHYS_ADDR_LOW/HIGH return values are ignored, so
on failure phys_addr_low/hi are left uninitialised and the assembled
address is passed straight to devm_ioremap(). When the SMU leaves them at
zero this maps physical address 0 and trips the ioremap-on-RAM warning:
amd_pmc AMDI000B:00: SMU cmd failed. err: 0xff
ioremap on RAM at 0x0000000000000000 - 0x0000000000ffffff
WARNING: CPU: 13 PID: 4592 at arch/x86/mm/ioremap.c:...
Check the return value of each SMU command and propagate it, and reject a
zero physical address before calling devm_ioremap(). |
| Use of uninitialized resource in SQL Server allows an authorized attacker to disclose information over a network. |
| Use of uninitialized resource in Microsoft Office Excel allows an unauthorized attacker to disclose information locally. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Skip Update HDCP Config In Transition State
Transition state does not have a valid dm_stream_ctx that should skip
configuring HDCP routine. The routine is valid to go through only when
a valid stream is created. |
| In the Linux kernel, the following vulnerability has been resolved:
power: supply: max17040: propagate register read errors
max17040_get_vcell() and max17040_get_soc() ignore errors returned by
regmap_read(). When an I2C transfer fails, the uninitialized register
value is converted and reported to userspace as a valid voltage or state
of charge. The polling worker can also replace the cached state of charge
with the bogus value and emit a spurious change event.
Propagate read errors through the power supply get_property callback and
keep the last valid cached state of charge when polling fails. |
| ws is an open source WebSocket client and server for Node.js. Prior to 8.20.1, the websocket.close() implementation is vulnerable to uninitialized memory disclosure when a TypedArray is passed as the reason argument. This vulnerability is fixed in 8.20.1. |
| Use of uninitialized resource in Windows Management Instrumentation allows an authorized attacker to disclose information over a network. |
| Use of uninitialized resource in Remote Desktop Client allows an authorized attacker to execute code over a network. |
| Use of uninitialized resource in Windows Spaceport.sys allows an authorized attacker to disclose information locally. |
| Use of uninitialized resource in Windows Task Scheduler allows an authorized attacker to disclose information locally. |
