| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| OP-TEE OS through 4.10.0, fixed in commit 7b8b494, contains a buffer underwrite vulnerability in the RSA NOPAD encrypt and decrypt operations within the mbedTLS software backend and SE050 hardware driver that allows a malicious Trusted Application to corrupt secure-world heap memory by supplying an input length exceeding the RSA modulus size. When src_len exceeds rsa_len, the subtraction expression wraps to a large unsigned value, causing a subsequent memcpy to write attacker-controlled data before the destination buffer in S-EL1 secure-world heap memory. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack_reasm: guard mac_header adjustment after IPv6 defrag
nf_ct_frag6_reasm() slides the packet head forward to drop the IPv6
fragment header and then unconditionally advances skb->mac_header:
skb->mac_header += sizeof(struct frag_hdr);
On the NF_INET_LOCAL_OUT defrag path the skb has no link-layer header
yet, so skb->mac_header is still the "not set" sentinel (u16)~0U. Adding
sizeof(struct frag_hdr) wraps it to a small value (0xffff + 8 == 7),
after which skb_mac_header_was_set() wrongly reports a MAC header is
present and skb_mac_header() points into the headroom.
The reassembler has done this unconditional add since it was introduced;
it was harmless while mac_header was a bare pointer, but wrong once
mac_header became a u16 offset whose unset state is the ~0U sentinel
tested by skb_mac_header_was_set(). The sibling net/ipv6/reassembly.c
does the same relocation and does guard the adjustment; mirror the
guard here. |
| Numeric truncation error in Windows DNS allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows DNS allows an authorized attacker to elevate privileges locally. |
| Integer overflow or wraparound in Windows DNS allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
geneve: gate GRO hint in geneve_gro_complete() on gs->gro_hint
geneve_gro_receive() reads the GRO hint through geneve_sk_gro_hint_off(),
which honours it only when the socket enabled IFLA_GENEVE_GRO_HINT
(gs->gro_hint). geneve_gro_complete() instead calls the low-level
geneve_opt_gro_hint_off() and acts on the hint unconditionally.
On a tunnel without the hint, receive aggregates the frames as plain
ETH_P_TEB while complete still honours an attacker-supplied hint option: it
inflates gh_len by gro_hint->nested_hdr_len (u8) and redirects the dispatch
type, so the inner gro_complete handler runs at nhoff + gh_len, an offset
receive never pulled nor validated, reading out of bounds of the skb head:
BUG: KASAN: slab-out-of-bounds in ipv6_gro_complete (net/ipv6/ip6_offload.c:196)
Read of size 1 at addr ffff88800fe91980 by task exploit/153
ipv6_gro_complete (net/ipv6/ip6_offload.c:196)
geneve_gro_complete (drivers/net/geneve.c:965)
udp_gro_complete (net/ipv4/udp_offload.c:940)
inet_gro_complete (net/ipv4/af_inet.c:1621)
__gro_flush (net/core/gro.c:306)
Gate the complete path on gs->gro_hint too via geneve_sk_gro_hint_off(), so
both paths agree. Tunnels that enable the hint are unaffected. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: SDCA: Validate written enum value in ge_put_enum_double()
ge_put_enum_double() passes the user-supplied enumeration index
item[0] to snd_soc_enum_item_to_val() without checking it against the
number of items in the enum:
ret = snd_soc_enum_item_to_val(e, item[0]);
snd_soc_enum_item_to_val() indexes the heap-allocated e->values[] array
with that index (e->values is set from a devm_kcalloc() of e->items
entries), so a control write with an out-of-range item[0] reads past the
end of the values buffer. The bounds check in
snd_soc_dapm_put_enum_double() only runs afterwards, so it does not
prevent the read here.
Reject an out-of-range item before using it, matching the other enum put
handlers.
This issue was pointed out by the Sashiko AI review bot while reviewing a
related enum-validation series:
https://lore.kernel.org/all/20260609125735.CEB651F00893@smtp.kernel.org/ |
| jupyterlab is an extensible environment for interactive and reproducible computing, based on the Jupyter Notebook Architecture. From 4.5.0 until 4.5.10 and 4.6.2, in jupyterlab/extensions/manager.py and jupyterlab/extensions/pypi.py, JupyterLab's PyPI extension manager enforces blocked_extensions_uris by comparing requested install names to blocklist entries with custom normalization that is weaker than PyPI package-name canonicalization. An authenticated user can request a PyPI-equivalent spelling such as JupyterLab.Git for a blocklisted package such as jupyterlab-git, and JupyterLab accepts the install request even though pip resolves the variant to the same package. Security impact requires an allowlist or blocklist intended to restrict package installation, the PyPI Extension Manager, and kernels and terminals that are disabled or delegated to remote hosts. The bypass lets an authenticated user install a prohibited extension, defeat integrity restrictions, and affect availability without gaining new read access. This issue is fixed in versions 4.5.10 and 4.6.2. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: resize log->one_page_buf when adopting on-disk page size
log_replay() allocates log->one_page_buf using the page size that was
chosen from the host PAGE_SIZE:
log->one_page_buf = kmalloc(log->page_size, GFP_NOFS);
Later, when a restart area is found, the log page size recorded on disk
is adopted:
t32 = le32_to_cpu(log->rst_info.r_page->sys_page_size);
if (log->page_size != t32) {
log->l_size = log->orig_file_size;
log->page_size = norm_file_page(t32, &log->l_size,
t32 == DefaultLogPageSize);
}
If the on-disk page size is larger than the size used for the initial
allocation, log->page_size grows but one_page_buf is left at its
original, smaller size. A subsequent unaligned read_log_page() then
reads log->page_size bytes into the undersized scratch buffer:
page_buf = page_off ? log->one_page_buf : *buffer;
err = ntfs_read_run_nb_ra(ni->mi.sbi, &ni->file.run, page_vbo, page_buf,
log->page_size, NULL, &log->read_ahead);
overflowing the allocation. This is reachable when mounting a dirty
NTFS volume whose log was formatted with a page size larger than the
buffer initially allocated on the mounting host (for example a 64K-log
volume mounted on a host that allocated a 4K scratch buffer).
Grow one_page_buf when the adopted on-disk page size exceeds the size
used for the initial allocation. On krealloc() failure the original
buffer is left intact and freed by the existing error path. |
| In the Linux kernel, the following vulnerability has been resolved:
net: enetc: check the number of BDs needed for xdp_frame
The size of xdp_redirect_arr array is ENETC_MAX_SKB_FRAGS. However, the
number of fragments contained in xdp_frame may be greater than or equal
to ENETC_MAX_SKB_FRAGS, which will cause the access to xdp_redirect_arr
to be out of bounds. |
| The Zephyr ADIN2111/ADIN1110 10BASE-T1S/T1L Ethernet driver (drivers/ethernet/eth_adin2111.c) reassembles received Ethernet frames in OPEN Alliance (OA) SPI mode by copying device-supplied 64-byte data chunks into a fixed static buffer ctx->buf of size CONFIG_ETH_ADIN2111_BUFFER_SIZE (default 1524 bytes). In eth_adin2111_oa_data_read(), each valid chunk was memcpy'd into ctx->buf[ctx->scur] and the write cursor scur advanced, with no check that scur + len stayed within the buffer. The number of chunks (up to 255, from the BUFSTS RCA field) and the per-chunk length are taken entirely from the frame data received off the wire; the cursor is only reset on a start-of-frame chunk. An attacker on the single-pair Ethernet segment can therefore send a frame whose reassembled size exceeds the configured buffer, causing the driver's RX offload thread to write attacker-controlled frame bytes past the end of the static buffer into adjacent driver/kernel memory (up to roughly 14.8 KB in the worst case). This is a remotely/adjacently reachable out-of-bounds write (CWE-787) that can corrupt memory and cause denial of service or potentially code execution. The defect was introduced when OA SPI support was added (commit 0ca8b0756b1) and shipped in releases v3.7.0 through v4.4.0. The fix adds a bounds check that drops the oversized frame and resets the cursor before the copy. |
| IBM Db2 11.5.0 through 11.5.9, and 12.1.0 through 12.1.5 is vulnerable to buffer overflow in the IXF IMPORT parser. |
| In the Linux kernel, the following vulnerability has been resolved:
cifs: validate DFS referral string offsets
parse_dfs_referrals() validates that the response header and referral
array fit in the received buffer, but each referral also contains string
offsets supplied by the server.
Those offsets are used to compute the DfsPath and NetworkAddress string
pointers without checking whether they still point inside the response
buffer. A malformed referral can therefore make the computed pointer
exceed the end of the buffer. The resulting negative max_len is then
passed to cifs_strndup_from_utf16(), and the non-Unicode path forwards it
to kstrndup() as a size_t, allowing strnlen() to read out of bounds.
Validate each string offset before deriving the string pointer. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to obtain sensitive information due to an out-of-bounds read. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote authenticated attacker to obtain sensitive information due to an out-of-bounds read. |
| In the Linux kernel, the following vulnerability has been resolved:
gue: validate REMCSUM private option length
GUE private flags can indicate that remote checksum offload metadata is
present. The private flags field itself is accounted for by
guehdr_flags_len(), but guehdr_priv_flags_len() currently returns 0 even
when GUE_PFLAG_REMCSUM is set.
This lets a packet with only the private flags field pass
validate_gue_flags(), after which gue_remcsum() and gue_gro_remcsum()
read the missing REMCSUM start/offset fields from the following bytes.
Account for GUE_PLEN_REMCSUM when GUE_PFLAG_REMCSUM is present so that
malformed packets are rejected during option validation. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: flowtable: fix and simplify IP6IP6 tunnel handling
Fix nf_flow_ip6_tunnel_proto() to use pskb_may_pull() instead of
skb_header_pointer() to ensure the outer IPv6 header is in the skb
headroom, which is required for subsequent packet processing. Move
ctx->offset update inside the IPPROTO_IPV6 conditional block since it
should only be adjusted when an IP6IP6 tunnel is actually detected.
Simplify the rx path by removing ipv6_skip_exthdr() and checking
ip6h->nexthdr directly, as the flowtable fast path only handles simple
IP6IP6 encapsulation without extension headers.
Drop the tunnel encapsulation limit destination option support from the
tx path to match, since the rx path no longer handles extension headers.
Remove the encap_limit parameter from nf_flow_offload_ipv6_forward(),
nf_flow_tunnel_ip6ip6_push() and nf_flow_tunnel_v6_push(), along with
the ipv6_tel_txoption struct and related headroom/MTU adjustments. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: fsl: fsl_audmix: Validate written enum values
fsl_audmix_put_mix_clk_src() and fsl_audmix_put_out_src()
convert the user-provided enum item with snd_soc_enum_item_to_val()
before checking whether the item is within the enum's item count.
The generic snd_soc_put_enum_double() helper performs that
validation, but these callbacks use the converted value first: the
clock-source path tests it with BIT(), and the output-source path
indexes the prms transition table with it.
Reject out-of-range enum items before converting them. |
| A weakness has been identified in Open Asset Import Library Assimp 17c12da. The affected element is the function Assimp::MDLImporter::ReadFaces_3DGS_MDL7 in the library code/AssetLib/LWO/LWOLoader.h of the component 3DGS MDL7 Model Parser. Executing a manipulation can lead to heap-based buffer overflow. The attack may be launched remotely. The exploit has been made available to the public and could be used for attacks. This patch is called ee77bb09a42a49843ac85ef64c14d2328b251df1. Applying a patch is advised to resolve this issue. |
| A vulnerability was detected in Edimax EW-7478APC 1.04. Affected is the function formWlSiteSurvey of the file /goform/formWlSiteSurvey. Performing a manipulation of the argument selSSID results in buffer overflow. The attack is possible to be carried out remotely. The exploit is now public and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
