| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: ufs: ufs-qcom: Fix UFS OCP issue during UFS power down (PC=3)
According to UFS specifications, the power-off sequence for a UFS device
includes:
- Sending an SSU command with Power_Condition=3 and await a response.
- Asserting RST_N low.
- Turning off REF_CLK.
- Turning off VCC.
- Turning off VCCQ/VCCQ2.
As part of ufs shutdown, after the SSU command completion, asserting
hardware reset (HWRST) triggers the device firmware to wake up and
execute its reset routine. This routine initializes hardware blocks and
takes a few milliseconds to complete. During this time, the ICCQ draws a
large current.
This large ICCQ current may cause issues for the regulator which is
supplying power to UFS, because the turn off request from UFS driver to
the regulator framework will be immediately followed by low power
mode(LPM) request by regulator framework. This is done by framework
because UFS which is the only client is requesting for disable. So if
the rail is still in the process of shutting down while ICCQ exceeds LPM
current thresholds, and LPM mode is activated in hardware during this
state, it may trigger an overcurrent protection (OCP) fault in the
regulator.
To prevent this, a 10ms delay is added after asserting HWRST. This
allows the reset operation to complete while power rails remain active
and in high-power mode.
Currently there is no way for Host to query whether the reset is
completed or not and hence this the delay is based on experiments with
Qualcomm UFS controllers across multiple UFS vendors. |
| In the Linux kernel, the following vulnerability has been resolved:
mtdchar: fix integer overflow in read/write ioctls
The "req.start" and "req.len" variables are u64 values that come from the
user at the start of the function. We mask away the high 32 bits of
"req.len" so that's capped at U32_MAX but the "req.start" variable can go
up to U64_MAX which means that the addition can still integer overflow.
Use check_add_overflow() to fix this bug. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: fix gpu page fault after hibernation on PF passthrough
On PF passthrough environment, after hibernate and then resume, coralgemm
will cause gpu page fault.
Mode1 reset happens during hibernate, but partition mode is not restored
on resume, register mmCP_HYP_XCP_CTL and mmCP_PSP_XCP_CTL is not right
after resume. When CP access the MQD BO, wrong stride size is used,
this will cause out of bound access on the MQD BO, resulting page fault.
The fix is to ensure gfx_v9_4_3_switch_compute_partition() is called
when resume from a hibernation.
KFD resume is called separately during a reset recovery or resume from
suspend sequence. Hence it's not required to be called as part of
partition switch.
(cherry picked from commit 5d1b32cfe4a676fe552416cb5ae847b215463a1a) |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: zstd - fix double-free in per-CPU stream cleanup
The crypto/zstd module has a double-free bug that occurs when multiple
tfms are allocated and freed.
The issue happens because zstd_streams (per-CPU contexts) are freed in
zstd_exit() during every tfm destruction, rather than being managed at
the module level. When multiple tfms exist, each tfm exit attempts to
free the same shared per-CPU streams, resulting in a double-free.
This leads to a stack trace similar to:
BUG: Bad page state in process kworker/u16:1 pfn:106fd93
page: refcount:0 mapcount:0 mapping:0000000000000000 index:0x0 pfn:0x106fd93
flags: 0x17ffffc0000000(node=0|zone=2|lastcpupid=0x1fffff)
page_type: 0xffffffff()
raw: 0017ffffc0000000 dead000000000100 dead000000000122 0000000000000000
raw: 0000000000000000 0000000000000000 00000000ffffffff 0000000000000000
page dumped because: nonzero entire_mapcount
Modules linked in: ...
CPU: 3 UID: 0 PID: 2506 Comm: kworker/u16:1 Kdump: loaded Tainted: G B
Hardware name: ...
Workqueue: btrfs-delalloc btrfs_work_helper
Call Trace:
<TASK>
dump_stack_lvl+0x5d/0x80
bad_page+0x71/0xd0
free_unref_page_prepare+0x24e/0x490
free_unref_page+0x60/0x170
crypto_acomp_free_streams+0x5d/0xc0
crypto_acomp_exit_tfm+0x23/0x50
crypto_destroy_tfm+0x60/0xc0
...
Change the lifecycle management of zstd_streams to free the streams only
once during module cleanup. |
| In the Linux kernel, the following vulnerability has been resolved:
media: s5p-mfc: Clear workbit to handle error condition
During error on CLOSE_INSTANCE command, ctx_work_bits was not getting
cleared. During consequent mfc execution NULL pointer dereferencing of
this context led to kernel panic. This patch fixes this issue by making
sure to clear ctx_work_bits always. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: udc: fix use-after-free in usb_gadget_state_work
A race condition during gadget teardown can lead to a use-after-free
in usb_gadget_state_work(), as reported by KASAN:
BUG: KASAN: invalid-access in sysfs_notify+0x2c/0xd0
Workqueue: events usb_gadget_state_work
The fundamental race occurs because a concurrent event (e.g., an
interrupt) can call usb_gadget_set_state() and schedule gadget->work
at any time during the cleanup process in usb_del_gadget().
Commit 399a45e5237c ("usb: gadget: core: flush gadget workqueue after
device removal") attempted to fix this by moving flush_work() to after
device_del(). However, this does not fully solve the race, as a new
work item can still be scheduled *after* flush_work() completes but
before the gadget's memory is freed, leading to the same use-after-free.
This patch fixes the race condition robustly by introducing a 'teardown'
flag and a 'state_lock' spinlock to the usb_gadget struct. The flag is
set during cleanup in usb_del_gadget() *before* calling flush_work() to
prevent any new work from being scheduled once cleanup has commenced.
The scheduling site, usb_gadget_set_state(), now checks this flag under
the lock before queueing the work, thus safely closing the race window. |
| In the Linux kernel, the following vulnerability has been resolved:
most: usb: fix double free on late probe failure
The MOST subsystem has a non-standard registration function which frees
the interface on registration failures and on deregistration.
This unsurprisingly leads to bugs in the MOST drivers, and a couple of
recent changes turned a reference underflow and use-after-free in the
USB driver into several double free and a use-after-free on late probe
failures. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: fix potential memory leak in wilc_mac_xmit()
The wilc_mac_xmit() returns NETDEV_TX_OK without freeing skb, add
dev_kfree_skb() to fix it. Compile tested only. |
| In the Linux kernel, the following vulnerability has been resolved:
net: stream: purge sk_error_queue in sk_stream_kill_queues()
Changheon Lee reported TCP socket leaks, with a nice repro.
It seems we leak TCP sockets with the following sequence:
1) SOF_TIMESTAMPING_TX_ACK is enabled on the socket.
Each ACK will cook an skb put in error queue, from __skb_tstamp_tx().
__skb_tstamp_tx() is using skb_clone(), unless
SOF_TIMESTAMPING_OPT_TSONLY was also requested.
2) If the application is also using MSG_ZEROCOPY, then we put in the
error queue cloned skbs that had a struct ubuf_info attached to them.
Whenever an struct ubuf_info is allocated, sock_zerocopy_alloc()
does a sock_hold().
As long as the cloned skbs are still in sk_error_queue,
socket refcount is kept elevated.
3) Application closes the socket, while error queue is not empty.
Since tcp_close() no longer purges the socket error queue,
we might end up with a TCP socket with at least one skb in
error queue keeping the socket alive forever.
This bug can be (ab)used to consume all kernel memory
and freeze the host.
We need to purge the error queue, with proper synchronization
against concurrent writers. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: snic: Fix possible UAF in snic_tgt_create()
Smatch reports a warning as follows:
drivers/scsi/snic/snic_disc.c:307 snic_tgt_create() warn:
'&tgt->list' not removed from list
If device_add() fails in snic_tgt_create(), tgt will be freed, but
tgt->list will not be removed from snic->disc.tgt_list, then list traversal
may cause UAF.
Remove from snic->disc.tgt_list before free(). |
| In the Linux kernel, the following vulnerability has been resolved:
hwrng: amd - Fix PCI device refcount leak
for_each_pci_dev() is implemented by pci_get_device(). The comment of
pci_get_device() says that it will increase the reference count for the
returned pci_dev and also decrease the reference count for the input
pci_dev @from if it is not NULL.
If we break for_each_pci_dev() loop with pdev not NULL, we need to call
pci_dev_put() to decrease the reference count. Add the missing
pci_dev_put() for the normal and error path. |
| In the Linux kernel, the following vulnerability has been resolved:
media: uvcvideo: Fix memory leak in uvc_gpio_parse
Previously the unit buffer was allocated before checking the IRQ for
privacy GPIO. In case of error, the unit buffer was leaked.
Allocate the unit buffer after the IRQ to avoid it.
Addresses-Coverity-ID: 1474639 ("Resource leak") |
| In the Linux kernel, the following vulnerability has been resolved:
powerpc/rtas: avoid device tree lookups in rtas_os_term()
rtas_os_term() is called during panic. Its behavior depends on a couple
of conditions in the /rtas node of the device tree, the traversal of
which entails locking and local IRQ state changes. If the kernel panics
while devtree_lock is held, rtas_os_term() as currently written could
hang.
Instead of discovering the relevant characteristics at panic time,
cache them in file-static variables at boot. Note the lookup for
"ibm,extended-os-term" is converted to of_property_read_bool() since it
is a boolean property, not an RTAS function token.
[mpe: Incorporate suggested change from Nick] |
| In the Linux kernel, the following vulnerability has been resolved:
ARM: OMAP2+: Fix memory leak in realtime_counter_init()
The "sys_clk" resource is malloced by clk_get(),
it is not released when the function return. |
| In the Linux kernel, the following vulnerability has been resolved:
gpu: lontium-lt9611: Fix NULL pointer dereference in lt9611_connector_init()
A NULL check for bridge->encoder shows that it may be NULL, but it
already been dereferenced on all paths leading to the check.
812 if (!bridge->encoder) {
Dereference the pointer bridge->encoder.
810 drm_connector_attach_encoder(<9611->connector, bridge->encoder); |
| In the Linux kernel, the following vulnerability has been resolved:
objtool: Fix SEGFAULT
find_insn() will return NULL in case of failure. Check insn in order
to avoid a kernel Oops for NULL pointer dereference. |
| In the Linux kernel, the following vulnerability has been resolved:
regulator: core: fix unbalanced of node refcount in regulator_dev_lookup()
I got the the following report:
OF: ERROR: memory leak, expected refcount 1 instead of 2,
of_node_get()/of_node_put() unbalanced - destroy cset entry:
attach overlay node /i2c/pmic@62/regulators/exten
In of_get_regulator(), the node is returned from of_parse_phandle()
with refcount incremented, after using it, of_node_put() need be called. |
| Improper Limitation of a Pathname to a Restricted Directory ('Path Traversal') vulnerability in WooCommerce WooCommerce One Page Checkout allows PHP Local File Inclusion.This issue affects WooCommerce One Page Checkout: from n/a through 2.3.0. |
| Improper Control of Filename for Include/Require Statement in PHP Program ('PHP Remote File Inclusion') vulnerability in CodexThemes TheGem Theme Elements (for Elementor) thegem-elements-elementor allows PHP Local File Inclusion.This issue affects TheGem Theme Elements (for Elementor): from n/a through <= 5.11.0. |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in CodexThemes TheGem Theme Elements (for WPBakery) thegem-elements allows DOM-Based XSS.This issue affects TheGem Theme Elements (for WPBakery): from n/a through <= 5.11.0. |
